15ppm Bilge Alarm (GBA-155)
GBA-155 Complying to IMO MEPC 107(49)
GBA-155 serves to continuously measure the concentration of oil in bilge and other waste water produced on a ship and produces alarm signal when oil concentration is 5 or 15 ppm
| Item | Description |
|---|---|
| Measuring Range | 0-30 ppm |
| Measuring Accuracy | 15ppm +/-5 ppm ( IMO Resolution MEPC 107(49) |
| Set Point | 15 ppm |
| Response Time | Time Delay :0 second (Below 5 sec) |
| Alarm Contacts / Rating | Normal / Alarm contacts |
| Source of Electricity | AC 100~ 220 V |
Oil Content Meter Spares
| Description | Drawing Number | Part Number |
|---|---|---|
| Sample Tube | BA-G-02 | GBA-507 |
| Fuse | BA-G-02 | GBA-508 |
| O-Ring for Sample Tube | BA-G-02 | GBA-509 |
| O-Ring for the Cap | BA-G-02 | GBA-510 |
| Wrench | BA-F-02 | GBA-511 |
| Brush | BA-G-02 | GBA-512 |
| Display Board with Front Cover | BA-G-02 | GBA-501 |
| Sensing Module | BA-G-02 | GBA-502 |
| Main Board | BA-G-02 | GBA-503 |
Georim GRB- Green Box
Georim Green Box records discharge information covering starting and ending dates and time of discharge, location, status and discharge volume , and in addition the duration of operation of the equipment Is included. We are authorized agents for GBA-155, Oily water separator, Georim, 15 ppm Bilge Alarm in Middle East.
Storage Information includes
Alarm Status
PPM Value
Volume of water discharged overboard.
Time and Date
GPS position
Oily Water Separators ( GRS Type)
Complying to IMO MEPC 107(49)
| Model | Capacity |
|---|---|
| GRS-10EB | 1.0 m3/HR |
| GRS-20EB | 2.0 m3/HR |
| GRS-25EB | 2.5 m3/HR |
| GRS-50 EB | 5.0 m3/HR |
| GRS-100EB | 10.0 m3/HR |
Oily Water Seprators (UST Type)
Complying to MEPC 60(33) regulations.
| Model | Capacity |
|---|---|
| GRS-02EB | 0.2 m3/HR |
| GRS-03EB | 0.3 m3/HR |
| GRS-05EB | 0.5 m3/HR |
Oily Water Separator Spares
| Description | Drawing Number | Part Numbers |
|---|---|---|
| Sheet Packing (P.S.U) | SP-10BGPH-03 | 9 |
| Sheet Packing (E.T.U) | SP-10BGPH-03 | 21 |
| Handhole Packing | SP-10BGPH-03 | 22 |
| Coalescer Filter (P.S.U) | SP-10BGPH-03 | 19 |
| Coalescer Filter (E.T.U) | SP-10BGPH-03 | 20 |
Electrical Spares
| Description | Drawing Number | Part Numbers |
|---|---|---|
| Fuse Element | PN-44226GH-02 | 1 |
| Fuse Element | PN-44226GH-02 | 2 |
| AUX Relay | PN-44226GH-02 | 3 |
| Pilot lamp | PN-44226GH-02 | 4 |
| Push Button | PN-44226GH-02 | 5 |
| Selector Switch | PN-44226GH-02 | 6 |
| Fuse for OLD | SP-100BGPH-04 | 10 |
Bilge Pump Spares
| Description | Drawing Number | Part Numbers |
|---|---|---|
| Upper V/V Fix Bolt | P-101B-03 | 24 & 29 |
| Lower V/V Fix Bolt | P-101B-03 | 26 |
| Valve Spring | P-101B-03 | 26 |
| Valve Rubber | P-101B-03 | 27 |
| Piston V-Packing | P-101B-03 | 56 |
| Cylinder Front Cover O-Ring | P-101B-03 | 57 |
Oily Water Separators (POS Type)
Complying to MEPC60(33) Regulations.
Coalescer Filters
Bilge Pump (Piston Type)
Sludge Pump (Single Screw Pump / monotype)
Hydrophore Unit (GRH Series)
Sewage Treatment Equipment
As per MEPC regulation Section 4.2.11 The Validity of calibration certificates should be checked at IOPP Annual/intermediate/renewal surveys. The accuracy of 15 ppm bilge alarms is to be checked by calibration and testing of the equipment conducted by a manufacturer or firm authorized by the manufacturer and should be done at intervals not exceeding five years or within the term specified in the manufacturer’s instructions, whichever is shorter. Alternatively the unit may be replaced by a calibrated 15 ppm bilge alarm. The calibration certificate for the 15 ppm bilge alarm, certifying the date of the last calibration check, should be retained on board for inspection purposes.The accuracy checks can only be done by the manufacturer or firm or persons authorized by the manufacturer.
Al Ghwasa Technical Eqpt Tdg LLC are the authorized sales and service manufacturer authorized agents for Georim Engineering Korea.